Exterior Lighting & Service Drop Work
Exterior upgrade combining new black flood light and modern wall sconce installs with service drop and meter assessment — clean weatherproof connections and code-compliant runs.
A selection of completed electrical work.
Exterior upgrade combining new black flood light and modern wall sconce installs with service drop and meter assessment — clean weatherproof connections and code-compliant runs.
Powered and wired a Navien boiler system with four Taco circulators on a custom zone manifold: dedicated circuits, low-voltage zone control board, and clean junctions for a multi-zone hydronic heating setup.
Tesla Wall Connector install in garage: dedicated 60A circuit, clean EMT conduit run from panel, and weatherproof junction — ready for daily charging.
Service and panel projects: dual panel rough-in, fully labeled breakers, panel replacements, and rewire of legacy boards — clean, organized, and inspection-ready.
Mixed lighting package: kitchen pendants and recessed cans, bedroom recessed lighting, bathroom vanity sconce, and exterior wall sconce — fully wired and dimmable.
Custom pendant lighting layout in a renovated open-plan space: precise laser-leveled placement, new circuits run from the attic, and clean brass fixture finish.
Relocated existing service drop and meter to accommodate new siding and new-construction additions — coordinated with utility, kept downtime to a minimum.
Dedicated circuits for six electric water heaters: junction header, individual disconnects, and clean whip runs to each Rheem tank — turnkey for new multi-unit building.
Replaced aging triple-meter bank with a modern 3-meter stack: new mast, individual emergency disconnects, and clean conduit runs — safer, code-compliant, and built to last.
Multi-unit service install: underground feeder trench, 6-position meter stack with individual emergency disconnects, and main service disconnect — fully labeled and code-compliant.
Full 400A service upgrade: new meter stack with two emergency disconnects, dual 200A interior panels, and complete feeder runs — code-compliant and inspection-ready.
Commercial hood install with rooftop exhaust fan: dedicated circuit, weatherproof disconnect, and exterior conduit run up to roof.
New service mast, meter, and main disconnect with solar PV inverter tie-in and rapid shutdown switch — full code-compliant install.
Kitchen electrical update: new outlets and dimmer switches, under-cabinet circuits, and main panel work with clear breaker labeling.
Full kitchen rewire in progress: ceiling rough-in for recessed lighting, wall circuits for outlets and appliances, and updated layout.
Complete basement build-out: rough-in wiring, recessed lighting, bath exhaust/light, vanity fixture, and exterior mini-split disconnect.
Full panel replacement with new breakers and grounding.
12 LED recessed lights installed across living and kitchen.
Tesla Wall Connector install with 60A circuit.
LED retrofit for 4,000 sq ft office space.
Diagnosed and resolved repeated breaker trips.
Landscape and security lighting installation.
Garage sub-panel install for workshop power.
Kitchen equipment circuits and code compliance.
Smart switch installation across the home.